| NHTSA Campaign Number: |
79V044000 |
| Vehicle/Equipment Make: |
FLXIBLE |
| Vehicle/Equipment Model: |
35096 |
| Model Year: |
1976 |
| Manufacturer Campaign Number: |
|
| Manufacturer Component Description: |
SUSPENSION |
| Manufacturers Involved in Recall: |
GRUMMAN FLXIBLE CORP. |
| Manufacturered: |
19761101 - 19781201 |
| Type of Report: |
V (Vehicle, Equipment or Tire) |
| Potential Number of Units Affected: |
1100 |
| Date Owner Notified By Manufacturer: |
19790123 |
| Recall Initiated By: |
19790123 |
| Manufacturer Responsible For Recall: |
FLXIBLE CORPORATION |
| Report Received Date: |
19790105 |
| Record Creation Date: |
19791012 |
| Regulation Part Number: |
|
| Federal Motor Vehicle Safety Standard Number: |
|
| Defect Summary: |
A HARDENED WASHER REQUIRED IN MOUNTING THE UPPER RADIUS ROD BRACKET TO THE TOP OF THE FRONT AXLE WAS OMITTED DURING ASSEMBLY. THE OMISSION OF THE HARDENED WASHER COULD CAUSE A GAP UP TO .063" BETWEEN THE TOP OF THE MOUNTING FLANGE AND THE STEERING GEAR ASSEMBLY. THIS GAP WILL PREVENT THE SPECIFIED CLAMPING FORCES FROM BEING APPLIED TO THE UPPER RADIUS ROD BRACKET. THE INABILITY TO CORRECTLY CLAMP THE UPPER RADIUS ROD BRACKET TO THE AXLE COULD CAUSE ABNORMAL STRESS LOADS TO BE APPLIED TO THE BRACKET DURING VEHICLE OPERATION. CONTINUED OPERATION UNDER THESE CONDITIONS COULD RESULT IN VERTICAL BRACKET FRACTURE. IF COMPLETE SEPARATION OF THE BRACKET OCCURRED, THE FRONT AXLE COULD SHIFT, CAUSING BINDING AND RUBBING OF THE STEERING SHAFT AND, EVENTUALLY, LOSS OF STEERING CONTROL. |
| Consequence Summary: |
|
| Corrective Summary: |
DEALER WILL INSPECT AND, IF NECESSARY, REPLACE BRACKETS WITHOUT CHARGE TO OWNER. |
