| NHTSA Campaign Number: |
98V231000 |
| Vehicle/Equipment Make: |
HONDA |
| Vehicle/Equipment Model: |
ACCORD |
| Model Year: |
1995 |
| Manufacturer Campaign Number: |
|
| Manufacturer Component Description: |
ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD |
| Manufacturers Involved in Recall: |
AMERICAN HONDA MOTOR CO. |
| Manufacturered: |
19940419 - 19970520 |
| Type of Report: |
V (Vehicle, Equipment or Tire) |
| Potential Number of Units Affected: |
967771 |
| Date Owner Notified By Manufacturer: |
19981008 |
| Recall Initiated By: |
19981008 |
| Manufacturer Responsible For Recall: |
AMERICAN HONDA MOTOR CO. |
| Report Received Date: |
19980922 |
| Record Creation Date: |
19980925 |
| Regulation Part Number: |
|
| Federal Motor Vehicle Safety Standard Number: |
|
| Defect Summary: |
VEHICLE DESCRIPTION: SEDAN, COUPE AND WAGON PASSENGER VEHICLES EXCEPT THE DX MODEL AND MODELS WITH V6 ENGINES. THE FACTORY INSTALLED AIR CONDITIONER WIRE HARNESS WAS IMPROPERLY ROUTED ALLOWING SOME WIRES TO RUB AGAINST EACH OTHER, EVENTUALLY CAUSING A SHORT CIRCUIT. |
| Consequence Summary: |
THE SHORT CIRCUIT CANPOSSIBLY CAUSE THE UNDERHOOD WIREING TO OVERHEAT AND SMOKE, CAUSING A FIRE IN THE ENGINE COMPARTMENT. A SHORT CIRCUIT CAN ALSO RESULT IN A BLOWN FUSE OR DEAD BATTERY. |
| Corrective Summary: |
DEALERS WILL INSPECT THE VEHICLES FOR PROPER ROUTING OF THESE WIRES. ANY HARNESS IMPROPERLY ROUTED WILL BE INSPECTED FOR DAMAGE AND THE ROUTING WILL BE CORRECTED. IF ANY INSULATION IS WORN THROUGH AND THE COPPER WIRES ARE EXPOSED, THE HARNESS WILL BE REPLACED. DEALERS WILL ALSO INSTALL PLASTIC TUBING TO PROTECT THE HARNESS. |
