| NHTSA Campaign Number: |
94V196000 |
| Vehicle/Equipment Make: |
INTERNATIONAL HARVESTER |
| Vehicle/Equipment Model: |
8200 |
| Model Year: |
1995 |
| Manufacturer Campaign Number: |
|
| Manufacturer Component Description: |
VEHICLE SPEED CONTROL:ACCELERATOR PEDAL |
| Manufacturers Involved in Recall: |
INTERNATIONAL TRUCK AND ENGINE |
| Manufacturered: |
19940101 - 19940601 |
| Type of Report: |
V (Vehicle, Equipment or Tire) |
| Potential Number of Units Affected: |
6449 |
| Date Owner Notified By Manufacturer: |
19941017 |
| Recall Initiated By: |
19941017 |
| Manufacturer Responsible For Recall: |
INTERNATIONAL TRUCK & ENGINE CORPORATION |
| Report Received Date: |
19941007 |
| Record Creation Date: |
19941028 |
| Regulation Part Number: |
|
| Federal Motor Vehicle Safety Standard Number: |
|
| Defect Summary: |
THE BASE OF THE ELECTRONIC ACCELERATOR PEDAL IS MADE OF DIE CAST ALUMINUM. THE BASE MOUNTS DIRECTLY TO THE CAB FIREWALL. THE CAB FIREWALL IS NOT RIGID ENOUGH OR FLAT ENOUGH AT THE MOUNTING SURFACE, CAUSING STRESS ON THE ACCELERATOR BASE THAT WILL CAUSE THE MOUNTING PADS ON THE BASE OF THE PEDAL ASSEMBLY TO FAIL AND TOTALLY SEPARATE FROM THE FIREWALL. |
| Consequence Summary: |
THIS CAN CAUSE LOSS OF SPEED CONTROL, DRIVER DISTRACTION, AND RESULT IN AN ACCIDENT. |
| Corrective Summary: |
DEALERS WILL INSPECT THE ACCELERATOR PEDAL ASSEMBLY AND INSTALL A PLATE BETWEEN THE ACCELERATOR MOUNTING BASE AND THE FIREWALL ON THOSE UNITS WHERE THE BASE IS NOT BROKEN AND HAS NO VISIBLE SIGNS OF A CRACK. IF THE BASE IS BROKEN OR CRACKED, THE ACCELERATOR ASSEMBLY WILL BE REPLACED WITH A NEW REDESIGNED ACCELERATOR PEDAL ASSEMBLY. |
