| NHTSA Campaign Number: |
96V233002 |
| Vehicle/Equipment Make: |
INTERNATIONAL |
| Vehicle/Equipment Model: |
8200 |
| Model Year: |
1997 |
| Manufacturer Campaign Number: |
|
| Manufacturer Component Description: |
SUSPENSION:REAR |
| Manufacturers Involved in Recall: |
INTERNATIONAL TRUCK AND ENGINE |
| Manufacturered: |
19960416 - 19961016 |
| Type of Report: |
V (Vehicle, Equipment or Tire) |
| Potential Number of Units Affected: |
1133 |
| Date Owner Notified By Manufacturer: |
19961203 |
| Recall Initiated By: |
19961203 |
| Manufacturer Responsible For Recall: |
INTERNATIONAL TRUCK & ENGINE CORPORATION |
| Report Received Date: |
19961122 |
| Record Creation Date: |
19961219 |
| Regulation Part Number: |
|
| Federal Motor Vehicle Safety Standard Number: |
|
| Defect Summary: |
THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION. |
| Consequence Summary: |
THIS LOCKING TAB PREVENTS THE WHEEL BEARING NUT FROM LOOSENING DURING VEHICLE OPERATION. IF THIS TAB IS DEFORMED, THE NUT CAN LOOSEN ALLOWING THE WHEEL TO SEPARATE FROM THE AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT. |
| Corrective Summary: |
DEALERS WILL REPLACE THE DRIVE AXLE HOUSING NUTS WITH A CONVENTIONAL WHEEL NUT HARDWARE SYSTEM. |
