| NHTSA Campaign Number: |
02V174000 |
| Vehicle/Equipment Make: |
INTERNATIONAL |
| Vehicle/Equipment Model: |
4300 |
| Model Year: |
2002 |
| Manufacturer Campaign Number: |
2507 |
| Manufacturer Component Description: |
POWER TRAIN:CLUTCH ASSEMBLY |
| Manufacturers Involved in Recall: |
INTERNATIONAL TRUCK AND ENGINE |
| Manufacturered: |
20001026 - 20020530 |
| Type of Report: |
V (Vehicle, Equipment or Tire) |
| Potential Number of Units Affected: |
13052 |
| Date Owner Notified By Manufacturer: |
20020719 |
| Recall Initiated By: |
20020719 |
| Manufacturer Responsible For Recall: |
INTERNATIONAL TRUCK & ENGINE CORPORATION |
| Report Received Date: |
20020712 |
| Record Creation Date: |
20020722 |
| Regulation Part Number: |
|
| Federal Motor Vehicle Safety Standard Number: |
|
| Defect Summary: |
ON CERTAIN HEAVY DUTY TRUCKS EQUIPPED WITH MANUAL TRANSMISSIONS, LOWER CLUTCH RODS WITH TURNBUCKLES ARE FAILING FROM FATIGUE NEAR THE TURNBUCKLE DUE TO BENDING FORCES EXPERIENCED DURING EACH CLUTCH PEDAL CYCLE. |
| Consequence Summary: |
THE CLUTCH ROD CAN BREAK WITHOUT WARNING AND MAKE IT DIFFICULT TO SHIFT AND IF THE CLUTCH ROD BREAKS WHILE THE VEHICLE IS STOPPED OR DECELERATING, THE VEHICLE COULD LUNGE UNEXPECTEDLY IN THE DIRECTION OF THE SELECTED GEAR, INCREASING THE RISK OF A CRASH. |
| Corrective Summary: |
DEALERS WILL REPLACE THE CLUTCH ROD ASSEMBLY WITH A SOLID ROD DESIGN THAT DOES NOT HAVE A TURNBUCKLE. OWNER NOTIFICATION BEGAN JULY 19, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825. |
